Digital Sight 10 Ver1.50

Software Details

Ver1.50 Firmware for Digital Sight 10 camera series for microscopes

1. Installation
To Install, use the Digital Sight 10 and PC.
– Extract “DS10_FPGA_v1.50.zip” to any folder.
– Connect the PC and the Digital Sight 10 via USB, and turn on the Digital Sight 10.
– Execute “DsCamUpdater.exe” in the “DS10_FPGA_v1.50” folder.
– Click “UPDATE”. The update will start immediately. Please wait until the update is complete. It takes about 1 minute.
– When the update is complete, the message “The camera update is completed” will be displayed. Click “OK”.
– Click “Finish” to close the updater. Please reboot the Digital Sight 10 for the update to take effect.

2. Modifications
– The sampling clock phase of the FPGA receiver that receives image sensor data has been optimized. Improved the phenomenon such as cross like noise that rarely occurred in the previous version.

3. Notes
– Digital Sight 10 does not support USB 2.0. Please Connect with USB 3.2.
– Never turn off the power or disconnect the USB cable while updating, as this may cause malfunction.

Release date: 30/04/2024